GMC K20
-
GMC K20 1990
LOOSE PIVOT BOLT HOLDING THE BRAKE PEDAL TO ITS SUPPORT BRACKET COULD DISENGAGE FROM THE NUT.
-
GMC K20 1990
ON C AND K MODELS, FEED AND OR RETURN FUEL LINES CAN CONTACT THE AUTOMATIC TRANSMISSION SHIFT LINKAGE CORDON SHAFT. IN ADDITION, ON K MODELS LINES MAY ALSO CONTACT FRONT PROPSHAFT. IN EITHER CASE THE FUEL LINES COULD BE DAMAGED RESULTING IN A FUEL LEAK.
-
GMC K20 1982
THE REAR AXLE SHAFTS RECEIVED IMPROPER HEAT TREATMENT DURING MANUFACTURE. THE SHAFT MAY BREAK AND THE TIRE AND WHEEL ASSEMBLY COULD DISENGAGE FROM THE VEHICLE.
-
GMC K20 1980
FATIGUE CRACKS MAY DEVELOP IN THE BRAKE VACUUM BOOSTER HOUSING. THIS MAY CAUSE A VACUUM LEAK AND REDUCE THE EFFECTIVENESS OF THE BRAKES. AFTER PROLONGED USE, THE CRACKS MAY DEVELOP TO THE EXTENT THAT THE BOOSTER MAY SEPARATE FROM THE VEHICLE.
-
GMC K20 1979
FATIGUE CRACKS MAY DEVELOP IN THE BRAKE VACUUM BOOSTER HOUSING. THIS MAY CAUSE A VACUUM LEAK AND REDUCE THE EFFECTIVENESS OF THE BRAKES. AFTER PROLONGED USE, THE CRACKS MAY DEVELOP TO THE EXTENT THAT THE BOOSTER MAY SEPARATE FROM THE VEHICLE.
-
GMC K20 1979
ON THE INVOLVED VEHICLES THE BRAKE STOPLIGHT AND CRUISE CONTROL SWITCH WHICH IS OPERATED BY THE BRAKE PEDAL MAY HAVE BEEN ASSEMBLED WITH AN INCORRECT LUBRICANT ON THE ACTUATING PLUNGER. THIS CAN CAUSE THE REAR BRAKE STOPLIGHTS TO BECOME INOPERATIVE AND THE CRUISE CONTROL, IF ACTIVATED, TO STAY ELECTRICALLY ENGAGED.
-
GMC K20 1976
THE ACCELERATOR PEDAL ROD IN COMBINATION WITH THE PEDAL INSTALLED ON THE INVOLVED VEHICLES MAY CUT THROUGH THE FLOOR PAN RUBBER MAT OR CARPET INTO THE THICK RESILIENT INSULATION PAD UNDERNEATH DURING HEAVY OR REPEATED FULL THROTTLE APPLICATIONS. AS A RESULT, THE ACCELERATOR PEDAL ROD MAY CATCH IN THE MAT OR CARPET, PREVENTING THE THROTTLE FROM RETURNING TO IDLE WHEN THE DRIVERS FOOT IS REMOVED FROM THE PEDAL.
-
GMC K20 1977
THE ACCELERATOR PEDAL ROD IN COMBINATION WITH THE PEDAL INSTALLED ON THE INVOLVED VEHICLES MAY CUT THROUGH THE FLOOR PAN RUBBER MAT OR CARPET INTO THE THICK RESILIENT INSULATION PAD UNDERNEATH DURING HEAVY OR REPEATED FULL THROTTLE APPLICATIONS. AS A RESULT, THE ACCELERATOR PEDAL ROD MAY CATCH IN THE MAT OR CARPET, PREVENTING THE THROTTLE FROM RETURNING TO IDLE WHEN THE DRIVERS FOOT IS REMOVED FROM THE PEDAL.