KENWORTH L700
-
KENWORTH L700 1982
LINE PRESSURE SURGES OCCUR WHEN THE TRANSMISSION IS IN HIGH GEAR LOCKUP DUE TO A PLUMBING ERROR. CONSEQUENCE OF DEFECT: LINE PRESSURE SURGES COULD CAUSE BODILY HARM THROUGH ERRATIC FIRE HOSE DELIVERY ACTION.
-
KENWORTH L700 1983
LINE PRESSURE SURGES OCCUR WHEN THE TRANSMISSION IS IN HIGH GEAR LOCKUP DUE TO A PLUMBING ERROR. CONSEQUENCE OF DEFECT: LINE PRESSURE SURGES COULD CAUSE BODILY HARM THROUGH ERRATIC FIRE HOSE DELIVERY ACTION.
-
KENWORTH L700 1986
LINE PRESSURE SURGES OCCUR WHEN THE TRANSMISSION IS IN HIGH GEAR LOCKUP DUE TO A PLUMBING ERROR. CONSEQUENCE OF DEFECT: LINE PRESSURE SURGES COULD CAUSE BODILY HARM THROUGH ERRATIC FIRE HOSE DELIVERY ACTION.
-
KENWORTH L700 1984
LINE PRESSURE SURGES OCCUR WHEN THE TRANSMISSION IS IN HIGH GEAR LOCKUP DUE TO A PLUMBING ERROR. CONSEQUENCE OF DEFECT: LINE PRESSURE SURGES COULD CAUSE BODILY HARM THROUGH ERRATIC FIRE HOSE DELIVERY ACTION.
-
KENWORTH L700 1985
LINE PRESSURE SURGES OCCUR WHEN THE TRANSMISSION IS IN HIGH GEAR LOCKUP DUE TO A PLUMBING ERROR. CONSEQUENCE OF DEFECT: LINE PRESSURE SURGES COULD CAUSE BODILY HARM THROUGH ERRATIC FIRE HOSE DELIVERY ACTION.
-
KENWORTH L700 1982
THE REAR BRAKES MAY NOT RELEASE AS QUICKLY AS SPECIFICATIONS REQUIRE. CERTAIN TRUCKS WERE EQUIPPED WITH AN INCORRECT SIZE AIR BRAKE LINE INSTALLED BETWEEN THE REAR BRAKE RELAY VALVE AND THE AXLE TEE FITTING. THE CONDITION IS NOT IN COMPLIANCE WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD 121, AIR BRAKE SYSTEMS.
-
KENWORTH L700 1983
THE REAR BRAKES MAY NOT RELEASE AS QUICKLY AS SPECIFICATIONS REQUIRE. CERTAIN TRUCKS WERE EQUIPPED WITH AN INCORRECT SIZE AIR BRAKE LINE INSTALLED BETWEEN THE REAR BRAKE RELAY VALVE AND THE AXLE TEE FITTING. THE CONDITION IS NOT IN COMPLIANCE WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD 121, AIR BRAKE SYSTEMS.
-
KENWORTH L700 1982
FRONT AXLE AIR BRAKE CHAMBER IS ATTACHED WITH A CLAMP AND BOLT ASSEMBLY THAT MAY NOT HAVE BEEN POSITIONED CORRECTLY, AND MAY CHAFE AGAINST THE FRONT BRAKE HOSE. CHAFING COULD RESULT IN AN AIR LEAK AND LOSS OF AIR TO THE FRONT BRAKES.
-
KENWORTH L700 1983
FRONT AXLE AIR BRAKE CHAMBER IS ATTACHED WITH A CLAMP AND BOLT ASSEMBLY THAT MAY NOT HAVE BEEN POSITIONED CORRECTLY, AND MAY CHAFE AGAINST THE FRONT BRAKE HOSE. CHAFING COULD RESULT IN AN AIR LEAK AND LOSS OF AIR TO THE FRONT BRAKES.
-
KENWORTH L700 1982
STEERING COMPONENTS MAY INTERFERE WITH EACH OTHER AND COULD LEAD TO SEPARATION OF STEERING LINKAGE. THE DRAGLINK, A COMPONENT IN THE STEERING LINKAGE THAT TRANSMITS TURNING MOVEMENTS TO THE WHEELS, MAY HAVE A CLAMP ON THE AXLE END WHICH HAS BEEN INCORRECTLY POSITIONED ON THE INBOARD SIDE OF THE DRAGLINK.
-
KENWORTH L700 1983
STEERING COMPONENTS MAY INTERFERE WITH EACH OTHER AND COULD LEAD TO SEPARATION OF STEERING LINKAGE. THE DRAGLINK, A COMPONENT IN THE STEERING LINKAGE THAT TRANSMITS TURNING MOVEMENTS TO THE WHEELS, MAY HAVE A CLAMP ON THE AXLE END WHICH HAS BEEN INCORRECTLY POSITIONED ON THE INBOARD SIDE OF THE DRAGLINK.
-
KENWORTH L700 1982
THE U SHAPED BOLTS THAT CONNECT THE SPRINGS AND SPRING SPACERS TO THE FRONT AXLE MAY NOT HAVE BEEN INSTALLED PROPERLY. THIS CONDITION COULD ALLOW THE AXLE TO SHIFT AND COULD DEGRADE THE STEERING CHARACTERISTICS OF THE VEHICLE.
-
KENWORTH L700 1983
THE U SHAPED BOLTS THAT CONNECT THE SPRINGS AND SPRING SPACERS TO THE FRONT AXLE MAY NOT HAVE BEEN INSTALLED PROPERLY. THIS CONDITION COULD ALLOW THE AXLE TO SHIFT AND COULD DEGRADE THE STEERING CHARACTERISTICS OF THE VEHICLE.
-
KENWORTH L700 1982
ON CERTAIN VEHICLES IMPROPER AIR HOSE ASSEMBLY PROCEDURES MAY HAVE RESULTED IN PIECES BEING LEFT IN THE HOSE. THESE PIECES COULD BLOCK THE HOSE AND CAUSE A MALFUNCTION.
-
KENWORTH L700 1979
DUE TO DEFECTIVE INSTALLATION PROCEDURES ON THE INVOLVED VEHICLES, THERE IS A POSSIBILITY OF SLACK ADJUSTER DAMAGE. THIS COULD RESULT IN BRAKE FAILURE ON THE REAR WHEEL END.
-
KENWORTH L700 1977
THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, ACCELERATOR CONTROL SYSTEMS, IN THAT DUE TO THE LOCATION OF THE LOWER THROTTLE RETURN SPRING AND THE TENSION IN BOTH THROTTLE SPRINGS, THE VEHICLE MAY NOT MEET THE RETURN TIME SPECIFIED IN THE STANDARD.
-
KENWORTH L700 1974
THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, ACCELERATOR CONTROL SYSTEMS, IN THAT DUE TO THE LOCATION OF THE LOWER THROTTLE RETURN SPRING AND THE TENSION IN BOTH THROTTLE SPRINGS, THE VEHICLE MAY NOT MEET THE RETURN TIME SPECIFIED IN THE STANDARD.
-
KENWORTH L700 1973
THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, ACCELERATOR CONTROL SYSTEMS, IN THAT DUE TO THE LOCATION OF THE LOWER THROTTLE RETURN SPRING AND THE TENSION IN BOTH THROTTLE SPRINGS, THE VEHICLE MAY NOT MEET THE RETURN TIME SPECIFIED IN THE STANDARD.
-
KENWORTH L700 1976
THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, ACCELERATOR CONTROL SYSTEMS, IN THAT DUE TO THE LOCATION OF THE LOWER THROTTLE RETURN SPRING AND THE TENSION IN BOTH THROTTLE SPRINGS, THE VEHICLE MAY NOT MEET THE RETURN TIME SPECIFIED IN THE STANDARD.
-
KENWORTH L700 1975
THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, ACCELERATOR CONTROL SYSTEMS, IN THAT DUE TO THE LOCATION OF THE LOWER THROTTLE RETURN SPRING AND THE TENSION IN BOTH THROTTLE SPRINGS, THE VEHICLE MAY NOT MEET THE RETURN TIME SPECIFIED IN THE STANDARD.
-
KENWORTH L700 1978
THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, ACCELERATOR CONTROL SYSTEMS, IN THAT DUE TO THE LOCATION OF THE LOWER THROTTLE RETURN SPRING AND THE TENSION IN BOTH THROTTLE SPRINGS, THE VEHICLE MAY NOT MEET THE RETURN TIME SPECIFIED IN THE STANDARD.